Telex MR-J2S- Manuel d'utilisateur télécharger pdf (Page 168)

12 - 23

12. OPTIONS AND AUXILIARY EQUIPMENT

MRR

MDR 16 5

18P5

MD 6

LG 1

BAT 9

MRR

MDR 16 5

MR-JCCBL2M-L

MR-JCCBL5M-L

MR-JCCBL2M-H

MR-JCCBL5M-H

MD 6

LG 1

BAT 9

MRR

MDR 16 5

18P5

MD 6

LG 1

BAT 9

Drive unit side

Encoder side

Plate

Drive unit side

Encoder side

Plate

Drive unit side

Encoder side

Plate

(Note) (Note) (Note)

Note. Always make connection for use in an absolute position detection system.

This wiring is not needed for use in an incremental system.

MR-JCCBL10M-L

MR-JCCBL30M-L

MR-JCCBL10M-H

MR-JCCBL50M-H

When fabricating an encoder cable, use the recommended wires given in Section 12.2.1 and the

MR-J2CNM connector set for encoder cable fabrication, and fabricate an encoder cable as shown

in the following wiring diagram. Referring to this wiring diagram, you can fabricate an encoder

cable of up to 50m(164.0ft) length including the length of the encoder cable supplied to the servo

motor.

When the encoder cable is to be fabricated by the customer, the wiring of MD and MDR is not

required.

Refer to Chapter 3 of the servo motor instruction manual and choose the encode side connector

according to the servo motor installation environment.

Note. Always make connection for use in an absolute position detection system.

This wiring is not needed for use in an incremental system.

MRR

BAT

For use of AWG22

Drive unit side

Encoder side

Plate

(Note)

(3M)

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 211 212

Commentaires sur ces manuels

Pas de commentaire

Telex MR-J2S- Manuel d'utilisateur Page 168

Commentaires sur ces manuels