Telex UAD4 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Microphones Telex UAD4. Telex UAD4 User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Instruction Sheet
General Description
The UAD4 Amplified Antenna Splitter makes it
possible to operate four UHF wireless diversity
microphone receivers on four separate frequen
-
cies using only two antennas.
Features
The UAD4 is equipped with TNC type connec
-
tors. Low loss coaxial cables are also supplied
for splitter to receiver antenna jack connections.
The UAD4 has an internal power supply. Power
out jacks and cables are provided to supply up
to four receivers thus eliminating excess power
supply clutter.
It also features a high degree of output isolation;
a necessity in multi-frequency systems to prevent
intermodulation.
The UAD4 Splitter is compatible with Telex
UHF diversity wireless receivers.
Rack panel mounting “ears” allow the UAD4 to
be mounted in a standard 19 inch equipment
rack. “Knock outs” in the ears allow front con
-
nection of antenna cables.
-1-
SPECIFICATIONS
Frequency Range 301614100 .................................................................................600-780 MHz
301614101.................................................................................780-900 MHz
3rd Order Intercept Output...........................................................................greater than 18 dbm
Net Gain ............................................................................................................greater than 2 dB
Noise Figure ...........................................................................................................less than 3 dB
Output Isolation...............................................................................................greater than 20 dB
Connectors, Antenna..........................................................................Standard TNC receptacles
Power Requirements................................................................................. 100-240VAC 50/60Hz
UAD4
CAT. NO. 301614100 600-780 MHz
CAT. NO. 301614101 780-900 MHz
AMPLIFIED UHF
ANTENNA SPLITTER
PN 804036 Rev A
T
elex
R
TELEX COMMUNICATIONS, INC. 12000 Portland Ave. South, Burnsville, MN 55337
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Instruction Sheet

Instruction SheetGeneral DescriptionThe UAD4 Amplified Antenna Splitter makes itpossible to operate four UHF wireless diversitymicrophone receivers on

Page 2 - SPLITTER

System ConfigurationFigure 2 illustrates the typical system configura-tion using the UAD4.Figure 3 illustrates an arrangement where twosplitters have

Page 3 - Figure 2

-3-TO RECEIVERSONLYTO RECEIVERSOR SPLITTERSTO RECEIVERS ONLY(DO NOT FEED SPLITTERS FROM SECONDARY UNITS)ANTENNAANTENNAINPUT AOUTPUT A1234OUTPUT B1234I

Page 4 - THIS END TOWARD TRANSMITTER

Antenna RequirementsThe UAD4 may be used with a variety of anten-nas. For best results, use a pair of ALP-450 di-rectional log periodic antennas. See

Page 5 - Coax Cable

Antenna Placement for Optimum Rangeand Rack MountingFor maximum range and when rack mounting,the antennas must be remotely located.The ALP-450 comes c

Page 6 - J11 POWER OFF

12 Volt Power On "Antenna In" JacksTo power UAA-500 in-line antenna amplifiers,12 volt power is available on the center pin ofthe antenna in

Page 7

UAD4 Accessories and Replacement PartsAC Power Cables550024000 Europe550024002 U.K.550024013 North America690513 JapanTP-2 50 OHM/TNC dummy load(For u

Page 8 - July 2004

PRINTED IN U.S.A.Copyright© 2004 by TelexTELEX COMMUNICATIONS, INC.All rights reservedJuly 2004

Commentaires sur ces manuels

Pas de commentaire